Usun Model: AB10 50-80 Bar Air Driven High Pressure Air Compressor Pump for Cylinder Testing

Usun Model: AB10 50-80 Bar Air Driven High Pressure Air Compressor Pump for Cylinder Testing

 CZPT  Design :AB10  10:one ratio  50-80  Bar  160mm driven   air pushed substantial force air

compressor pump for cylinder tests  

 

CZPT Data for substantial strain air driven high strain

CZPT pump   
 

 Our CZPT Air Amplifiers are pneumatically driven reciprocating piston/plunger pumps

 

and are ratio devices  that utilise low pressure compressed air driving a larger diameter

 

 piston (area x pressure), which is linearly connected to a smaller air piston.

 

 1.  AIR Travel Segment

The air travel section is composed of a mild fat piston total with seals working within an

 

aluminum barrel. The diameter of the air piston is 100mm. When compressed air is supplied to

 

the pump the air pushes the air piston down on a compression stroke

 

 Under the control of pilot pins (poppet valve) induced at every single finish of the stroke

 

Essential attributes

one )  stainless metal wetted materials of building

two)  Specialised development components obtainable

three) PTFE stress seals as CZPT

four) Separation in between gas & pneumatic seals

five) No airline lubrication necessary

6) 120mm stroke minimizes cycle rate & raises life

7) Appropriate for most dangerous locations

eight) Available as a full packaged system 

Main technological knowledge  

Typical complex information for higher stress pneumatic booster testing pump  

Principal complex parameter
Product Stress ratio Bare minimum inlet pressure PI(Bar) Optimum Outlet pressure PO(Bar) Outlet force formula PO Inlet port dimension Outlet porst dimension Highest Flow fee L/min= 7 Bar
AB02 2:01 1 sixteen 2PA PT3/8” PT3/8” 513@PI=seven
AB03 3:01 one 24 3PA PT3/8” PT3/8” 420@PI=seven
4AB02 2:01 1 16 2PA PT1/2” PT1/2” 1450@PI=seven
AB04 4:01 one.7 32 4PA PT3/8” PT3/8” 382@PI=seven
AB05T five:01 one.7 41.five 5PA+PI PT1/2′ PT1/2” 710@pi=seven
AB07 seven:01 three.4 56 7PA PT3/8” PT3/8” 274@PI=seven
AB08T eight:01 three.four 67.four 8PA+ PI PT3/8” PT3/8” 482@pi=7
AB10 10:01 3.4 80 10PA PT3/8” PT3/8′ 225@PI=seven
AB15 fifteen:01 8.1 a hundred and twenty 15PA PT3/8” PT3/8′ 185@PI=seven

Remark one) Maxium outlet force are at an air driven strain of eight bar or 116 PSI ,for lengthy life making use of

of this kind of pump ,we recommend that air pushed pressure ought to be not far more than eight Bar  .

Common application of such 

AIR AMPLIFIER Product COMPARISON Desk

To choose the proper amplifier for your software you will need to 

know the  following parameters:

The offered air strain & quantity

The sought after pressure and stream charge

If you are not sure of these parameters but know a competitor brand’s product quantity,

 use the air amplifier product comparison table below to help you choose the

 right CZPT  air amplifier.
 

CZPT

Haskel

Maximator

Maxpro

HII

AB04

 

SPLV3

DLA5-one

 

AB07

AA-eight

     

AB10

       

AB15

AA-fifteen

 

DLA15-1

 

AB05T

AAD-five

GPLV5

DLA5

5A-DS-five

                                                                                 Factory  pictures 

 

Usun Model: AB10 50-80 Bar Air Driven High Pressure Air Compressor Pump for Cylinder Testing