SS316L Mvr Type Forced Circulation Evaporator

SS316L Mvr Type Forced Circulation Evaporator

SS316L Forced circulation evaporator for Nacl crystallization

 

This is a System for Ammonium Sulfate creation named Double Influence Forced Kind Circulation Evaporation Crystallizer, Or Double Result OSLO Crystallizer. feeding is liquid, last solution is the salt for marketing. 

 

Double Result Forced Type Circulation Evaporation Crystallizer is operating below vacuum, so it is power preserving. forced variety pump also help for slurry crystal liquid movement, dismiss pipeline blocking or scaling. 

 

Double Effect Compelled Type Circulation Evaporation Crystallizer mixed with 1st effect heater, 1st influence separator, 2nd result heater, 2nd impact separator, 1st preheater, 2nd preheater, 3rd preheater, 4th preheater,and condenser, pumps, pipeline and valves etc. 

 

Double Result Forced Kind Circulation Evaporation Crystallizer is also fit for proceed manufacturing of : Sodium Sulfate, Ammonium Sulfate, Tomato Paste generation, NaCl , lithium carbonate ,large salt waste h2o etc. 

 

This equipment is CZPT with conductive oil heating with secure temperature of 200-220ºC

 

Following is the picture which machinery put in in client’s factory:

one. Introduction for compelled circulation evaporator 

 

one) . Double result compelled circulation evaporator 

Model : GLFC-02-XXXX

Handing capacity ( (T/hr ) : two,4,5,6,10,11…

 

two) . Single result forced circulation evaporator :

Product : GLFC-02-XXXX

Handing potential ( T/ hr ) : 1,1.five,two…

 

2. Software Location : 

It is suitable for the evaporation and crystallization of resources with large focus, higher viscosity, insoluble solids and so on .

For case in point, the recovery of sodium chloride, sodium sulfate, ammonium chloride, ammonium sulfate, and so on.

 

three. Largely parameter :

 

1). The focus ratio is massive and the circulation type is forced, so that the liquid with more substantial viscosity is simple to movement and evaporate.

2).By means of the pressured circulation, the evaporator can be heated evenly in the tube and can stop the “dry wall” phenomenon.

3).The down sides are mostly the big volume of the pump and the relatively higher electrical energy use. At the same time, thanks to the massive flow of the pump, the products will vibrate significantly and it must be connected to the support of the workshop or the metal composition.

 

four.Technique introduction 

Evaporator, separator (crystallizer), condenser, circulation pump, inter motion pump or substance handle valve, vacuum and drainage program, sub cylinder, procedure platform, electrical instrument control cupboard, valve and pipeline technique.

 

 

 

SS316L Mvr Type Forced Circulation Evaporator